Blueprint
Quantum state transfer through a lossy bus: fundamental error limits for every control pulse, with application to IBM's meter-scale interconnects📱 5 short screens

📱 The paper in five short screens, for a phone or a first look: the result, what it says in words, how it is proved, what has been checked, and where to try it. Nothing here loads Python.

🎯 The result 1 / 5

Theorem 4.1.

Under H1–H2 with \(\kappa \ge \gamma \), for every control satisfying (1) and every \(T{\gt}0\),

\begin{equation} \boxed {P(T)\le \frac{e^{-\gamma T}}{1+(\kappa -\gamma )/(G^2T)}} \end{equation}
1

💬 In plain words 2 / 5

A transfer has two ways to lose the excitation. If it goes slowly, the qubits decay: that is the factor $e^{-\gamma T}$. If it goes fast, the excitation must pass through the bus, and the bus loses more: with couplers of strength $G$, moving the excitation in time $T$ forces the bus to hold it for an integrated time of at least $\tilde P/(G^2T)$ (Cauchy–Schwarz), and the bus loses at the excess rate $\kappa-\gamma$ while it holds it. No pulse escapes both. The bound holds for every shape, phase and duration and for any number of bus modes, because the proof only uses the three inequalities (3) of the Setting. For the loss ratio of an IBM link ($\kappa/\gamma=4.2$) the best pulses found by optimal control lie within $4$–$12\%$ of it (Figure 1). Machine-checked in Isabelle (\texttt{loss\_floor}), for derivatives outside a countable set.

🛠️ How it is proved 3 / 5

What the paper contributes

A qubit hands its state to another qubit through a lossy bus (a resonator, a waveguide or a cable mode), with each coupler bounded by $G$. The paper gives error floors that hold for every control pulse, every duration and any number of bus modes, and applies them to IBM’s meter-scale interconnect.

The lab Check your link computes the floor of your own link with the same code as the paper’s tables.

Open in the laboratory, with the values of the paper: IBM Q240–Q247 · IBM Q241–Q246 · IBM Q242–Q245 · IBM Q243–Q244 · Heya et al. · Chang et al. · Burkhart et al. (1 − P) · unequal couplers (10.9 / 7.1 MHz) · g/2π = 22.5 MHz · towards 10⁻⁴ (design map). Each opens the three labs of the section with those values: the floor, the bound at the measured duration, the pulses, the error budget, the design map and the sliders.

It rests on:

🛡️ What is checked 4 / 5

🟢 4 formal · 🟡 2 formal in part · 🔵 2 computation · 🔴 2 by hand · ⚪ 2 cited / no proof here.

Proof: in this note · Covers: not formalized · Cite: doi:10.5281/zenodo.23836449

🔎 What a referee has to check by hand →

🧪 Try it 5 / 5

Labs in your browser (they load Python the first time):

📕 The paper (PDF)📘 The full blueprint

📎 Cite: doi:10.5281/zenodo.23836449